Tsk Tsk
05-20-2011, 07:44 PM
a ruby-inset golvern target shield
On the reverse of the golvern target shield, a complex arrangement of gears, cogs, and shafts link a series of tightly overlapping plates about the edges so that they can swivel synchronously while still maintaining most of their strength. A small pin locks the plates firmly in place. You judge that the plates could swivel both inward and outward from their current position.
5x shield you can change the size of at will. Goes from kidney, target, round, then tower... the description changes as the size changes.
>open shield
You flip open the locking pin on the mechanism holding the edges of the shield in place.
>push shield
As you push on the edges of your shield, they ingeniously fold in on themselves, making the shield a bit smaller.
Roundtime: 3 sec.
CB:5M Wizgem3 Twice!
On the reverse of the golvern target shield, a complex arrangement of gears, cogs, and shafts link a series of tightly overlapping plates about the edges so that they can swivel synchronously while still maintaining most of their strength. A small pin locks the plates firmly in place. You judge that the plates could swivel both inward and outward from their current position.
5x shield you can change the size of at will. Goes from kidney, target, round, then tower... the description changes as the size changes.
>open shield
You flip open the locking pin on the mechanism holding the edges of the shield in place.
>push shield
As you push on the edges of your shield, they ingeniously fold in on themselves, making the shield a bit smaller.
Roundtime: 3 sec.
CB:5M Wizgem3 Twice!