PDA

View Full Version : Go2 issues



subzero
04-27-2011, 09:19 PM
Found a couple problems with go2 while grouped. The first one isn't registering as a climbing failure and immediately goes into the wait-for-group mode rather than attempting to climb again:


[Thanatoph, Lower Landing]
The mountain levels off here, opening into an enormous landing. Worn smooth by the passage of many years and many feet, the landing spreads out far enough to hold hundreds of people. Dominating the landing, enormous ancient stone stairs carved into the mountain form a jagged, meandering spine winding up the side of Thanatoph. Rough-hewn and oversized, the stairs appear hard to climb. You also see a stone troll.
Obvious paths: east, southeast, northwest
Razorfang followed.
>
[go2]>climb stair
Climbing well, you adeptly move along the stairs. As your confidence rises, your concentration lapses and then you miss a foothold. Screaming, you plunge towards the ground below.

You smack the ground with a sickening thud.

Roundtime: 10 sec.
PR>
Your disk arrives, following you dutifully.
PR>look
[Thanatoph, Lower Landing]
The mountain levels off here, opening into an enormous landing. Worn smooth by the passage of many years and many feet, the landing spreads out far enough to hold hundreds of people. Dominating the landing, enormous ancient stone stairs carved into the mountain form a jagged, meandering spine winding up the side of Thanatoph. Rough-hewn and oversized, the stairs appear hard to climb. You also see the Necromonger disk and a stone troll.
Also here: Razorfang
Obvious paths: east, southeast, northwest
PR>
P>
[go2]>stand
You stand back up.
>
[go2: Waiting for your group... ]

The other is that go2 wasn't updated with the new group strings (You add XXXX to your group.) and will not recognize that new string in order to continue moving.

Drew
04-27-2011, 09:28 PM
Yeah that climb is really hard and go2 has never recognized a failure.