Fletching question

[Derekl33]

Ok this might be a totally stupid question but when fletching and I go to measure my arrow shaft with my bow it tells me "The composite bow appears to already be loaded." I can't figure out how to get past this step because I can't figure out how to "unload my bow". Any help at all?

[Hecates]

bows dont load at all, if your sure about the command and bow, assist and get that bow fixed

[thefarmer]

If it's a wandbow, it can be loaded.

[mgoddess]

Why would you have to "load" or "unload" for the measuring step of Fletching? You don't even use the LOAD command...

Fletching on Krakiipedia (http://www.krakiipedia.org/wiki/Fletching) says the command to use is: MEASURE MY SHAFT WITH MY <BOW, CROSSBOW OR DART>

[waywardgs]

the syntax is "measure my shaft with my bow." Just to be sure, have your bow in your left hand. If you're typing that and it's not working, something's up.

[DoctorUnne]

the syntax is "measure my shaft

haha really?

[Bhuryn]

This happened with my bow. Remove the arrow from it (mine actually had a couple in it).

[AnticorRifling]

Why would you have to "load" or "unload" for the measuring step of Fletching? You don't even use the LOAD command...

Fletching on Krakiipedia (http://www.krakiipedia.org/wiki/Fletching) says the command to use is: MEASURE MY SHAFT WITH MY <BOW, CROSSBOW OR DART>
I used that command once and got some wicked string burns.

[mgoddess]

Why would you have to "load" or "unload" for the measuring step of Fletching? You don't even use the LOAD command...

Fletching on Krakiipedia (http://www.krakiipedia.org/wiki/Fletching) says the command to use is: MEASURE MY SHAFT WITH MY <BOW, CROSSBOW OR DART>
I used that command once and got some wicked string burns.
http://content.pyzam.com/funnypics/misc/DoingItWrong6.jpg